To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
In 1894, a national association formed, recreating itself in 1918 as the National Federation of Master Painters and Decorators of England and Wales, then changing its name once again to the British Decorators Association before merging, in 2002, with the Painting & Decorating Federation to form the Painting & Decorating Association. The Construction Industry Joint Council, a body formed of both unions and business organizations, today has responsibility for the setting of pay levels.
These are some fantastic questions to ask and I particularly like the one that is concerned about safety for the painters. After all, if you have a large home and you’re hiring them to paint the exterior of that home then they’ll likely be on scaffolding. Because of that, you need to make sure that the contractor not only provides appropriate safety training, but has the correct liability insurance as well.
This feared question gets to the heart of who will be performing work in your home and whether your home and belongings will be safe. Sadly, there have been numerous documented cases around the country where employees of a hired contractor have burglarized, injured, or even killed the homeowner. What’s worse, in most cases it was later found that the bad employee had a criminal background that was unknown to the employer. In learning about who will be performing the work in your home, you should ask additional questions about their hiring policy and whether they conduct criminal background checks.
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.