When coverage is difficult to estimate, add more rather than less when doing DIY wall painting. You can always pour the leftover back into cans. For large jobs, use the bucket and a roller screen rather than a roller tray. It’s much faster to load your roller with the screen than to use a roller pan. Simply dunk the roller into the paint bucket, then roll it along the screen until it stops dripping.
Research the licensing requirements for your area. These laws governing professional contractor work will be different depending on where you live. It’s important to be aware of these laws and what they mean from the outset. Contact the licensing board for your state or district to find out more about what you’ll need to do to get your business off the ground.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
Specify whether the contractor or you will supply the paint. Check Consumer Reports' paint ratings: In its tests, some relatively inexpensive paints performed better than more expensive paints and cost $10 to $20 less per gallon. But keep in mind that most paints will resist cracking, peeling, mold and mildew. Who does the painting — and how well they do it — is more important than what's in the bucket.
I am a painting contractor and have been since 2001. Make sure the estimate provides in writing: What is EXCLUDED as well as INCLUDED. It should state the manufacturer and type of paint going to be used. Estimate says ALL LABOR AND MATERIALS. My estimates to my customers say "guaranteed coverage" eliminates the conversations of 1 coat vs 2 coat. I have my customers submit colors 5 days prior to start date. Customers need to inform me if they are going to use pure white, dark reds, oranges, and bright yellows they need to inform me in that 5 day window, so I can adjust my pricing for 3 coats. Although this more uncommon now than years past because a lot of paint manufacturers have primer with paint products. Let the contractor know if your doing accent walls. This takes longer to cut in straight lines and it requires the contractor to purchase more paint. If you add anything on the scope of work have the painter write out the description and cost prior to them doing the work. Have the estimate say how many days it will take to perform the work. Ask how many workers will be doing the job. Make sure to enforce that number of workers their everyday until the job is complete. Do not give final payment until you do a final walk through. Walk the job when its almost complete and point out areas that you want fixed prior to the contractors final walk through. Its best to do while the workers are still in that particular area as they will have tarps down and areas covered and it will be easier for them to take care of. Purchase a roll of blue tape and stick it to areas that you want fixed. This is called a punch list.
If you are going to hire a contractor (professional painter) give a room by room punch list of the fixing of holes small or big, have it identified for the painter to tell you if you need a drywall finisher or if he does this type of work good. Wall repairs can be 3-5 steps to do repairs ( one per day for good drying of patching material and a good sanding) this is what gives you a good paint job only using high quality paint.

Home Painter Co

×