Every painting job develops a unique choreography as ladders go up and come down and tarps are unrolled and folded up. But two basic principles remain: 1) Start at the top and work down. 2) Work in the shade, out of the sun's glare. As the dance proceeds, keep an eye on the weather. Rain can wash freshly applied latex right off the wall, and a temperature dip below 50 degrees F two days after application can interfere with adhesion and curing and dull the sheen of glossy paints. (Latexes like Sherwin-Williams's Duration and Benjamin Moore's MoorGard Low Lustre are formulated to tolerate temps as low as 35 and 40 degrees, respectively.)
This article with comments was terrific - it was so informative. I found the advice useful. It addressed specifics like the condition of the dry wall surfaces, any additional repairs such. pin holes, chalking, smoothing of wall surfaces, absorption of paint and number of coats that may be needed. It should also include insurance coverage, and reflect the clean-up afterwards. Having a written contract with the company's letterhead is a must.
Some proposals simply say to paint the walls and ceiling and never specify the number of coats to be applied. If the colors are similar enough, it's possible to get away with one coat of paint and not discount your pricing. No matter how hard you try, tiny, pin-sized air holes will pop exposing the original walls. This may not bother you if you can't notice it, but principally speaking you should have paid your painter less for the work.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
Painting contractors work in the property maintenance sector. Depending on their skills and resources, they might specialize in painting different types of buildings, including houses and apartments, or commercial properties, such as offices, factories or retail outlets. Some contractors work directly for property owners; others find work through real estate firms, rental agents and property maintenance companies.
Ideally, you want a variety of older and newer projects, and you especially want to check on a very recent project, such as something completed last month. When you do get the references list, don’t take the information for granted. Take a few minutes to check these references. Ask these homeowners about the experience while services were provided and also how well the job has held up over time.
Years back our city’s classical music station made a midnight move and sold itself out from under its loyal listeners. I’m not even sure the staff knew of it until it had been sold, signed, and sealed. There was a lot of hollering of betrayal and the like, but things change and after over 50 years of Bach and Mozart it was going off the air one night at 10:00 and returning the next day at 6:00 a.m as Christian Contemporary.
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.