Attic Fan Installation Bathroom Fan Repair Ceiling Fan Installation Ceiling Fan Repair Electric Wall Heater Installation Electrical Panel Installation Electrical Panel Repair Electrical Panel Upgrade Electrical Wiring Installation Electrical Wiring Upgrade Exhaust Fan Installation Holiday Lighting Installation LED Interior Light Conversion Light Fixture Installation Light Fixture Repair Light Fixture Replacement Light Switch Installation Outlet Installation Outlet Repair Spa Wiring Installation
The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
Specify whether the contractor or you will supply the paint. Check Consumer Reports' paint ratings: In its tests, some relatively inexpensive paints performed better than more expensive paints and cost $10 to $20 less per gallon. But keep in mind that most paints will resist cracking, peeling, mold and mildew. Who does the painting — and how well they do it — is more important than what's in the bucket.
I am very pleased with this book. I think it has very good information. It seems to be written by an expert and I wanted expert advice. I know it is an older book, but I think his knowledge is very helpful. I needed advice. I have had work done on my house that did not work out well, so I needed to try to inform myself. I think this book has been very helpful.
Our project foreman, as well as our staff, are full time, professional house painters which means that our attention to detail is second to none when it comes to your project. From selecting the right date to start the project, colors, project staging through to completion, we concern ourselves with every single aspect to make sure that your complete satisfaction has been reached. We will not stop until it has been achieved.
A thorough scrubbing is a must before painting any exterior surface. It removes the dirt and broken-down paint residues that keep fresh coats from adhering and gets rid of mildew that grows on paint in all but the most arid climates. Most contractors clean with pressure washers, but in the hands of someone unfamiliar with the equipment, these can gouge wood, shatter glass, and drive water behind siding and trim. Using a hose, a pump sprayer, and a scrub brush is slower but safer, and just as effective.
If less than half the old paint is left, however, it may be worth stripping it all off. Guertin gets rid of stubborn remnants using shrouded grinders (like the PaintShaver), infrared paint strippers (such as the Speedheater), or chemical strippers (like Multi-Strip), then smooths the wood with a course or two of sanding. When siding (or bank accounts) can't take the shock of a total strip job, Rich O'Neil, of Masterwork Painting in Bedford, Massachusetts, has successfully hidden rough, well-adhered paint under Peel Bond, a thick primer.

Paint Contractor Company

×