I've seen this done many years ago by a guy who did all sorts of jobs where I lived. My dad caught him painting his boss's roof and he was watering down the paint. We've had a hard time trying to get a painter for our house. We've had a guy that had been remmended by a neighbor and he hasn't showed up to paint for 2 weeks. I want to call him and my husband says no. I'm 69 years old and I'm about ready to go and paint our 2 porches, I've painted all my life and all the inside of our home. Maybe that's the way it should be with everyone that can paint pretty good.
Here is where this affects you as a consumer. You select a painter with a contract that says 2 coats, $500 down. You give the company the deposit and pick your colors a couple of days before the project starts. The painter goes to the store with your colors and figures out they are deep base. He (or she) not only needs to charge you more for the paint, but he also needs to charge you for a dark gray primer coat. Ninety nine percent of the time that primer coat is going to be really, really expensive since you already gave a deposit.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
When their bids are successful, contractors meet customers to finalize their requirements and plan the order and timing of work. Contractors estimate the time required for surface preparation, painting several coats and drying time between coats. For interior painting jobs, they might have to allow time for clearing rooms. Exterior painting schedules might be dependent on the weather in different parts of the country. Exterior painting is not practical in very wet or very cold conditions.
As a former professional painter, something that drives me crazy is when I see painters cut in around wall plates. First of all, the amount of time that it takes to cut in is usually much longer than the amount of time that it takes to simply remove the wall plate. Secondly it does not look nearly as clean as it does when the wall plate is removed and thirdly it can invariably leave paint on the wall plate itself which also looks sloppy. Make sure the painter takes them off and then reinstalls them. It's less time.
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
I was taught to paint by a professional and when estimating the amount of paint needed, I always allow for a second coat just to make sure of coverage. We interviewed a painter who tried to tell me I bought poor quality paint without knowing where I purchased it, and stated he would have to buy all new paint. He had not seen the cans and was just guessing so I asked him where I should buy paint from now on. It was the same place I had purchased my paint and he wanted to charge me an extra 20 a gallon more than what I paid for. Needless to say, I have interviewed numerous painters and they are not all honest.
Oh, where to begin? Let me start with 'watered down paint'. 25-50% before the material gets to the site? Impossible. You would basically be painting with water at that point. It would be less of a hassle, and cost, to simply use proper material. You would be forced to apply three coats instead of two, as the coverage would be horrible. Whatever cost you think might be saved in materials would be lost in labor.
To industrial and institutional. I also own and operate a professional painting company of elite painters ONLY 5 ELITE PAINTERS, and pay them good money for being elite. Less is better in my opinion.The fact is this a homeowner and a painting company owner can both be taken advantage of by hustlers and liars and amateurs posing as pros. I have had many laborers tell me they can paint. " Oh yes sir I can paint, I'm a painter of 8 years. Yes sir I can cut a straight line." Some people will say and do anything to get a buck. If yoir on the job to see their rookie mistakes you may have time to save your reputation before disaster ensues and fire them on the spot. As a painting Company owner if your not on the job with your crew at least 3 out of 6 days every week your taking a huge risk of damaging your reputation and losing the respect of your team. Homeowners want to deal with you or the crew boss (jobs site supervisor) not "the painter". Many things I have read are right on. Painters for the most part will milk a clock for all they can and still do a good job. But amateurs will leave your projects in shambles and the only ones to pay for it is the contractor and the homeowners. But an elite painter and crew will try to complete a project as quickly as possible and move on to the next one. They understand bonuses, incentives, and promotions. My company provides the opportunity for a homeowner to meet each member of the crew and shake there hand on day one. There is also a differentiation between the crew boss and the crew by the uniforms they wear. Should the homeowners have any issue at all they know exactly who to go to to get results. This eliminates the age old problem of who screwed up? I have found that by me putting on my whites and giving my crew the opportunity to out do themselves on each project it ignites competition, pride in skill, and excellent commraderie amongst the team. We all hold each other accountable. Choose your contractor by the crew not the owner. The crew is a direct reflection of the Company owner. No room for rookies on fine finish painting. Go pro for painting and you won't regret it. With that being said homeowners should always remember that you get what you pay for. With paint and services. In most cases it will be well worth a few extra bucks to get elite results. Never go with the cheapest bid there is always a reason why it's so low.