Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers.

I learn a lot from this show and it help in my building maintenance job. i like this about the regulator on gas meter but for the cut away I know it had to be that way but Richard could you have mentioned that there was a vent on the regulator. I had a coworker ask me to check the vent and make sure it was clear, but from your cut away and no mention of a vent in the demo I didn't know there was a vent on the regulator so for next time there may need to be 2 cut aways explaining what the meter is and how to be safe.
This feared question gets to the heart of who will be performing work in your home and whether your home and belongings will be safe. Sadly, there have been numerous documented cases around the country where employees of a hired contractor have burglarized, injured, or even killed the homeowner.  What’s worse, in most cases it was later found that the bad employee had a criminal background that was unknown to the employer.  In learning about who will be performing the work in your home, you should ask additional questions about their hiring policy and whether they conduct criminal background checks.
The cost to paint the exterior of your home will vary depending on the size of your home, the condition of your siding, type of paint used and other factors. The average cost for labor and supplies ranges between $1,800-$3,800 and it may cost $6,500 or more for a large, custom project. In addition, you may need to pay more if there is damage to your siding or other challenging aspects of your job.
Enforcement of this Act by the Painter-Stainers Company was sought up until the early 19th century, with master painters gathering irregularly to decide the fees that a journeyman could charge, and also instigating an early version of a job centre in 1769, advertising in the London newspapers a "house of call" system to advertise for journeymen and also for journeymen to advertise for work. The guild's power in setting the fee a journeyman could charge was eventually overturned by law in 1827, and the period after this saw the guild's power diminish, along with that of the other guilds; the guilds were superseded by trade unions, with the Operative United Painters' Union forming sometime around 1831.[2]
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
So why not just paint your own home. I'm not a painter, so my wife and I take our time, buying the paint and supplies, and doing our own painting. Yes, we need to tape, and it's not perfect, but we get the satisfaction of seeing our completed work. Get the supplies, sliders for your furniture, and patience and go for it. That way YOU have control over the entire project.
A fellow (actually lives in the same neighborhood) by the name of Wayne Hickey (843-655-0366) painted the ceilings and most of the walls of our house in February 2017. He got paint all over my light fixtures, all over my trim around the doors, and had visible lap marks everywhere on the walls. He came back and rectified some of the problems, but not all, as I have noticed as I have had time to look more carefully at the work he and his assistant did. His assistant had no idea (not a clue) how to roll paint on a wall or ceiling. Some places were not covered. He said he would pull nails for pictures and then re-insert the nails exactly where they were. This he did not do as he promised. He painted over the nails. His assistant had no idea how to use a paint roller. I have painted all my life, and would have done this work myself, but I just had a full knee replacement and the other knee is in bad shape. I just could not do the work. Wayne is a pleasant and congenial individual, but he can not cut in a ceiling or wall to my satisfaction - not even close. He should have a putty knife and wet cloth with him all the time to correct any paint that might get applied where it shouldn't. That is something I always did as a painter. I would not recommend Wayne to paint anybody's home.
Hi Elaine, We would be happy to get you connected with a painting and wallpaper pro. You can submit a service request on our website: http://www.homeadvisor.com/ or browse reviews for local pros here: http://www.homeadvisor.com/c.html. We can also have a project advisor reach out to assist you if you send your contact information to [email protected] –HASupport
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.

Over the past year I have had several jobs given to 2 Angie's list recommendations and 1 not from a recommendation. They all have one thing in common, lack of sufficient and correct preparation to save time, labor, and the fact that they put a person in charge that was a cut corners type of worker. The two from Angie's list sent worker/s back to try touch up problems, but once the job is not prepared correctly in the first place any extra work is like putting a band-aid on a dirty wound.
Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
Before we start, you will have to choose your color. If you would like to replicate a color already on your wall, you can use an old can of paint for reference, or you can take a chip to the paint store. We can help you identify the color, the finish, and type of paint with our visualizer tools, and we also offer a Color Consulting Service if you need help coming to a decision.
Hi Elaine, We would be happy to get you connected with a painting and wallpaper pro. You can submit a service request on our website: http://www.homeadvisor.com/ or browse reviews for local pros here: http://www.homeadvisor.com/c.html. We can also have a project advisor reach out to assist you if you send your contact information to [email protected] –HASupport
Years back our city’s classical music station made a midnight move and sold itself out from under its loyal listeners. I’m not even sure the staff knew of it until it had been sold, signed, and sealed. There was a lot of hollering of betrayal and the like, but things change and after over 50 years of Bach and Mozart it was going off the air one night at 10:00 and returning the next day at 6:00 a.m as Christian Contemporary.
If you are going to hire a contractor (professional painter) give a room by room punch list of the fixing of holes small or big, have it identified for the painter to tell you if you need a drywall finisher or if he does this type of work good. Wall repairs can be 3-5 steps to do repairs ( one per day for good drying of patching material and a good sanding) this is what gives you a good paint job only using high quality paint.
Research the licensing requirements for your area. These laws governing professional contractor work will be different depending on where you live. It’s important to be aware of these laws and what they mean from the outset. Contact the licensing board for your state or district to find out more about what you’ll need to do to get your business off the ground. 

My husband has been a professional painter over 30 years. He prides himself in his high level of work ethic and customer satisfaction. He stays up to date on techniques and finishes. He gives Very detail and accurate appraisals with contracts. At an alarming rate, as he starts to finish the last day or the day before, the client starts nit picking and being disrespectful towards his work when every day prior to that, they were very pleased, as he request ongoing satisfaction throughout the job. Then they don't to want pay remaining balance, bicker about final cost, or stop payment. He has a crew he has to pay whether the customer does or doesn't honor the contract as well as our own household expenses. Wasted time ,labor, money and effort lost. Now how do we fix this? Remind yourself and clients that a contract is based on honor.
×